This kit includes five rugged gator clips designed for automotive testing,
and will connect to test leads that use industry standard banana-plugs (4mm)
with or without a shroud, such as, AES, Fluke, Pomona, etc.
Related Products
9ft. Shielded Lead Set
ST3 Test Leads are designed to withstand automotive environments:
– Shielded from tip-to-tip for maximum noise immunity
– Heat resistant
– Flexible
– Small enough to easily pass under hoods and through windows for road testing.
Each lead is constructed using quality shielded cable and connectors. They are insulation and resistance tested to ensure that they are of the highest possible quality. Each test lead features high quality BNC connectors or banana-plugs. The test end features shrouded banana plugs that allow the use of a wide variety of probes such as pin tips, alligators, back-pin probes, piercing probes and more.
Coil On Plug Inductive Signal Probe
$366.18
Coil On Plug Inductive Signal Probe
$366.18
$366.18Add to cart
Coil On Plug Inductive Signal Probe
Coil On Plug (COP) and Signal Probe
The TA204 COP and signal probe from Pico Technology is the easiest and fastest non-intrusive way to check coil-on-plug ignition coils and spark plugs.
- Find misfires fast
- Displays scope patterns of the secondary, faster than scoping the primary
- Works on all automotive scopes capable of displaying ignition patterns
- Can also be used to investigate injectors and other inductive actuators
- Flexible design allows for easier access to hard-to-reach components
- No batteries required
Like distributors, spark plug wires are starting to disappear from cars. With the new COP ignition systems the ignition coils are connected directly to the spark plugs — eliminating the need for the spark plug wires. With no high-voltage spark wires, a COP probe is required to be able to pick up the secondary ignition waveform.
As standard the TA204 COP probe is supplied as a kit (PP357) complete with the TA033 BNC to BNC cable in order to connect to your automotive
How does it work?
The coil–on–plug and signal probe works with most COP systems; it requires no special adaptors, no foil strips, and no batteries. The Pico coil-on-plug and signal probe eliminates the need for back-probing: to use the probe simply press the probe against the coil.
Along with testing COP systems, the coil-on-plug and signal probe can also be used to obtain many other signals, including a secondary ignition waveform on conventional ignition systems.
Designed to save you time, effort and money, the coil-on-plug and signal probe is the fastest way to test both conventional coil-on-plug secondary ignition systems.
EsiTest #180 LOADpro Dynamic Test Leads
$123.45
EsiTest #180 LOADpro Dynamic Test Leads
$123.45
$123.45Add to cart
EsiTest #180 LOADpro Dynamic Test Leads
LOADpro finds these problems FAST: High Corrosive Resistance Shorts to Ground Open Circuits LOADpro Test Leads load the circuit to see if
COP Secondary Paddle Probe
Easily scope COP and DIS ignition systems using the AES COP Secondary Paddle Lead (Capacitive).
This rugged 10-foot long, capacitive secondary lead includes a flexible yet sensitive ‘paddle’ that picks up the secondary signal from any COP system on the road today. The thin ‘paddle’ gets into tight spots that no bulky probe can.
